duplex mode

英 [ˈdjuːpleks məʊd] 美 [ˈduːpleks moʊd]

网络  双工模式; 双面打印模式; 双工方式; 双功型; 当前双工模式

计算机



双语例句

  1. Support backpressure flow control in half duplex working mode.
    支持半双工工作模式下的反压流控制。
  2. By default, the FE electric interface operates in full duplex mode.
    缺省情况下,FE的电接口为全双工模式。
  3. When the gigabit ethernet work on UTP, it must adopt the4pairs UTP at the full duplex mode, and need to increase some new requirement of performance parameters return loss, NEXT, PSNEXT.
    千兆以太网在UTP上运行时,采用4对全双工方式工作,需增加对UTP的回波损耗、近端串扰、功率和近端串扰等新性能参数的要求。
  4. As CAN communication controller communicates by semi duplex mode, it's RXD pin connects with TXD pin that can make the design compactly, but the controller is not connected with transceiver, communication distance is short and the anti-jamming characteristic debases.
    由于CAN通讯控制器采用半双工方式通讯,若将通讯控制器的接收端和发送端相连,可简化设计亦能够实现通讯,但是无法与收发器连接,从而缩短了通讯距离并降低了抗干扰性。
  5. The tensile, tensile-unload experiments and SEM fracture surface observation were used to investigate the effect of loading speed on room-temperature fracture mechanism of TiAl-based alloys with fully lamellar ( FL) and duplex ( DP) microstructure at displacement-controlled mode.
    通过拉伸、拉伸卸载实验及扫描电镜(SEM)断口观察,研究了在位移控制加载方式下,加载速度对具有全层(FL)组织和双态(DP)组织的TiAl基合金断裂机理的影响。
  6. The value of width can be acquired ingeniously by using duplex latch mode while there is a hole defect in the steel plate.
    用两次锁存法可巧妙地提取有孔洞缺陷时的板宽值。
  7. This paper describes the structure designing and the experiment result of a new duplex multi mode fiber rotary joint.
    本文阐述了一种新的两芯多模光纤旋转接头的设计原理及实验结果。
  8. One was based on time division duplex ( TDD) mode;
    一种是基于时分双工(TDD)模式下最大信道增益而设计的;
  9. Because of the half duplex communication mode, it is important to solve the problem of communication conflict, so as to improve the reliability and the stability of the system.
    因其通信方式大多是半双工的,解决其总线数据传输的冲突,即通信避障,就成了提高其工作可靠性、稳定性的关键和前提。
  10. A Master-Slave Distributed Microcomputer Controlled Duplex Cross Transmitted Mode for an Industrial and Closed-Circuit Television Supervisory System
    主&从分布式微机控制、双工纵横传输式工业闭路电视监视系统
  11. Half duplex ( HDX). FDX-normal response mode and FDX-asynchronous response mode of HDLC respectively is simulated. The results of simulation are analysed and illustrated.
    HDLC半双工(HDX)、全双工正常响应方式(FDX-NRM)和全双工异步响应方式(FDX-ARM)的模拟。
  12. Furthermore, the controller is designed for duplex output according to push-pull mode, which can be applied for double-wire welding.
    同时脉冲控制器设计为两路输出,按照推挽式设计,可进行双丝焊焊接。
  13. And the TiAl matrix has a duplex microstructure, and the fracture mode is transgranular cleavage fracture.
    通过多步热处理,可以得到双态组织和晶粒更为细小均匀的近γ组织的TiAl基体,复合材料的断裂模式转变为穿晶解理断裂。
  14. It adopt TDD duplex mode, smart antennas, joint detection and other new technologies, bring much profits as well as challenges for the whole system.
    采用了TDD双工方式、智能天线、联合检测等新技术,在为系统带来增益的同时也带来了许多挑战。
  15. RFID card and swipe used between duplex communication mode wireless data transmission, and realize a rapid response system.
    RFID卡与门禁系统之间采用无线双工通讯方式进行数据传输,实现系统的快速响应。
  16. TD-LTE uses time-division duplex working mode, and suits for dynamic distribution channel According to the asymmetry of network traffic.
    TD-LTE采用时分双工的工作模式,适合根据非对称的上下行业务流量来动态分配信道。
  17. In this paper, the wireless data radio takes the GPS differential positioning as a starting point, takes the FSK modulation mode, can complete the wireless transmission of data in S frequency band with the time division duplex operation mode.
    本文设计的无线数传电台以用于GPS差分定位为出发点,采用FSK的调制方式,能在S频段以时分双工的工作模式完成数据的无线传输。
  18. HFC duplex transmission systems is a novel network transmission mode, which develop rapidly with the demand for value-added services of CATV and enables television transmission network system transformed fully from simplex into duplex.
    有线电视HFC双向传输系统,是随着CATV增值业务的需求,单向电视传输系统面临全面改造成双向网络的现状,迅速发展起来的一种新型网络传输形式。
  19. It adopts time division duplex mode. It can be allocated bandwidth flexible and can adjust time slot base on different service types for uplink and downlink which increases bandwidth efficiency.
    它采用时分双工的模式,可以灵活的分配带宽资源,并能根据业务类型自适应的调整上、下行分配的时隙数,提高了频谱利用率。